Zig-Zag King Skateboard Care: Cleaning and Storage Tips

Quick answer

Treat the Zig-Zag King deck like a printed maple board: wipe it dry after every session, keep water away from the plies and bearings, and store it flat or hanging with the graphic protected. That routine covers most skateboard cleaning tips and deck maintenance without harsh products.

Step-by-step Zig-Zag King skateboard care

1. Brush off loose dirt first: Use a soft brush or dry cloth to sweep grip-tape dust and road grit off the deck before any wiping. Common mistake: scrubbing a dry deck with a wet rag, which pushes grit into the print and can scratch it. Always remove loose dirt dry before introducing any moisture.
2. Wipe the printed surfaces with a dry microfiber cloth: Wipe the bottom graphic and top print gently with a clean, dry microfiber cloth. For sticky marks, dampen a corner of the cloth very lightly and dry the area immediately. Checkpoint: the deck should feel dry within a minute. Keep the cloth barely damp, never wet enough to leave visible moisture on the wood.
3. Clean wheels and bearings separately: Remove the wheels and wipe them with a damp cloth, then dry them fully. Clean bearings according to their own manufacturer's instructions rather than flushing them on the deck. Common mistake: spraying cleaner directly onto the assembled board, which lets liquid reach the bearings and plies. If you have not installed trucks and wheels yet, skip this step until your setup is complete.
4. Dry everything completely before reassembly: Let the deck, wheels, and hardware air-dry indoors before putting the board back together. Checkpoint: run a finger along the truck mounting area and wheel seats; any cool or damp feel means more drying time. Assembling a damp board traps moisture where you cannot see it.
5. Store the deck flat or hanging, graphic protected: Keep the Zig-Zag King deck indoors, away from damp floors and direct sun. Store it flat on a shelf or hang it by the trucks with the printed side facing away from sunlight. Common mistake: leaning it against a radiator or leaving it in a car trunk, where heat and humidity can warp the maple plies. A dry, room-temperature spot is more important than a fancy rack.
6. Check the deck monthly for print wear and ply separation: Look along the edges for lifting plies and check the graphic for fading or peeling. Address small issues early by keeping the board drier and out of the sun. Checkpoint: if the print starts to lift, stop using wet cleaning methods on that area. Monthly checks catch moisture damage before it spreads.

Product facts that shape the routine

• Zig-Zag King Skateboard: Custom print 8-inch skateboard deck featuring the iconic King booklet artwork, made from 7-ply American Maple wood. The printed surface and maple plies both prefer dry cleaning and dry storage, so avoid soaking the deck or using solvent-heavy cleaners.

  

• Zig-Zag King Skateboard: Trucks and wheels are not included with the deck. If you are setting up the King deck from scratch, bearing care and truck cleaning only become part of your routine once you install your own hardware.