Clipper Butane: How to Refill Your Lighter Properly

By TPB Marketplace | Published: 2026-10-27

Category: How-to Guides

Learn the correct way to refill a Clipper lighter using Clipper Butane. Step-by-step instructions with common mistakes to avoid for a safe, lasting refill.

Quick answer

Refilling a Clipper lighter is straightforward: purge old gas, align the nozzle, press firmly for a few seconds, then let it settle before use. Using Clipper Butane ensures a clean, odorless fill.

Why use Clipper Butane?

Clipper Butane is 7x refined, meaning it's pure and odorless. This reduces the chance of clogging your lighter's nozzle and gives a consistent flame. Other brands may work, but using the recommended butane avoids residue buildup and extends your lighter's life.

What you'll need

A Clipper refillable lighter, a can of Clipper Butane (available in 16ml, 138ml, or 300ml sizes), and a well-ventilated area. No tools required.

How to refill your Clipper lighter step by step

Purge the lighter: Turn the flame adjustment dial to the lowest setting. Press the refill valve (on the bottom) with a small tool or the tip of the butane can to release any remaining gas. You'll hear a hiss—wait until it stops. Skipping the purge can cause air pockets, leading to a weak flame or a lighter that won't light.
Align the butane can nozzle: Shake the Clipper Butane can well. Hold the lighter upside down. Insert the nozzle of the butane can firmly into the refill valve. Make sure it's straight and fully seated. A crooked nozzle can cause butane to spray out instead of filling the tank, wasting gas and creating a mess.
Press and hold for 5 seconds: Press down on the butane can for about 5 seconds. You should feel the lighter getting cold. Release and wait 10 seconds before repeating if the lighter isn't full. Overfilling can damage the lighter's seal. If butane leaks out, stop immediately—the tank is full.
Let the lighter rest: After refilling, wait at least 2 minutes before using the lighter. This allows the butane to warm up and stabilize at room temperature. Using the lighter immediately can produce a weak or sputtering flame because the gas is still cold and under uneven pressure.
Test and adjust the flame: Turn the flame adjustment dial to your desired height. Strike the flint or press the ignition. If the flame is too low or high, adjust the dial and try again. If the lighter still won't light after refilling, you may have an air lock—purge and refill again.

Product facts

Clipper Butane: Clipper Butane is 7x refined, pure, and odorless. Available in 16ml, 138ml, or 300ml sizes. Higher refinement means fewer impurities, which helps prevent nozzle clogs and ensures a clean burn every time you refill.
Clipper Butane